Deutz 1012 Dokumentacja Pobierz pdf (Strona 165)

Service Training

Page 7

Section 4.5

4.5.2.2 SPEED CONTROL FROM 11/95

From 11/95 the speed control lever has been provided with an overload protection. The adjustment

procedure is as follows.

- With the control cylinder (1) retracted, slide the retainer (2) on the lever (7) as far as possible away from

the engine and tighten both the cheese head screws (3).

- Move the lever as far as the low idle stop (6) by rotating the threaded rod (5) and lock the threaded rod

with the nut (4).

- Start the engine and fully extend the control cylinder (1) by operating the accelerator.

NOTE: The brake pedal must be held in the fully depressed position.

- Loosen both cheese head screws (3).

- Slide the retainer (2) on the lever (7) as far as the upper idle stop and fix with the cheese head screws (3).

- Retract the control cylinder (1) to the home position and check the low idle stop again, readjust it if

necessary.

09.96

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 281 282

Brak uwag

Deutz 1012 Dokumentacja Strona 165