Deutz 1012 Dokumentacja Pobierz pdf (Strona 248)

Service Training

Section 4.9

Page 22

12.05

INSTALLING THE IGNITION CONTROL UNIT

NOTE: Prior to installing the ignition control unit, set

cylinder 1 of the internal combustion engine at

top dead centre on the compression stroke.

- Push timing pin (9) through the recess in the hub into the

hole in the housing.

- Check by inserting the 3mm timing pin (5) through the

toothed disc into the housing.

- Check the O-ring on the flange and replace, if neces-

sary.

- Place the ignition control unit (1) in the mounting posi-

tion. Be sure to push the pin through the slot in the gear

wheel.

- Fasten the flange by means of the M8 nuts and tighten

the nuts to 22 Nm.

- Push the gear wheel against the hub and fasten the gear

wheel with the help of the special screws (7). Tighten the

screws to 28 Nm.

- Withdraw the timing pin.

- Mount the timing case cover.

- Install the connector of the ignition control unit.

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 281 282

Brak uwag

Deutz 1012 Dokumentacja Strona 248